Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 232 (ELECTRICAL COMPONENT LOCATOR)SWITCHES
2013 Mini Cooper Countryman, Standard Trans
Section 232 (Electrical Component Locator): Switches
2013 Mini Cooper Countryman, Standard TransSECTION Switches
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2004 BMW 545i, 2004 BMW 530i, 2004 BMW 525i, 2003 BMW M5, and 2003 BMW 540i. However, it is still accessible from the selected car via links, so may be relevant.
SWITCHES LOCATION
| Component | Location |
|---|---|
| Brake Fluid Level Switch (B18) | Left rear of engine compartment. See Figure. |
| Brake Light Switch (S29) | Left side of dash. See Figure. |
| Clutch Pedal Position Switch (S32) | Left side of dash. See Figure. |
| Dual Temperature Switch (S36) | Right front of engine compartment. See Figure. |
| High Pressure Switch (B8) | Right front of engine compartment. See Figure. |
| Park Brake Switch (S31) | Rear center console. See Figure. |
| Park/Neutral Position Switch (Y19) | Center console. See Figure. |
| Temperature Switch, Radiator Shutter (S2000) | Rear of engine. See Figure. |
| Underhood Light Switch (S19) | Left rear of engine compartment. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.