86 21... Removing gas spring retaining bracket

2013 Mini Cooper Countryman, Standard TransSECTION 86 21... Removing gas spring retaining bracket
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2013 BMW 135i, 2013 BMW 128i, 2012 BMW 135i, 2012 BMW 128i, and 2011 BMW 135i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Remove gas spring.
refer to 86 21... REMOVING GAS SPRING .
Remove ball pivot,
Refer to 86 21... REMOVING BALL PIVOT .

Release screws (1) and remove gas spring retaining bracket (2) from mounting bracket (3).

Installation: 

Install retaining bracket so that it is centered in elongated holes.

Tightening Torque,

refer to 86 21 11AZ, see 86 21 HOOD

Fig 1: Identifying Gas Spring Retaining Bracket Screws
G05780611Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.