Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2214 (GENERAL ELECTRICAL SYSTEM - REPAIR)PLUG CONNECTION, TERMINAL, POWER DISTRIBUTION BOX61 13... BUTT CONNECTOR FOR REPAIRING A PLUG CONNECTION
2013 Mini Cooper Countryman, Standard Trans
61 13... Butt connector for repairing a plug connection
2013 Mini Cooper Countryman, Standard TransSECTION 61 13... Butt connector for repairing a plug connection
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 61 0 300 . See GENERAL ELECTRICAL SYSTEM - SPECIAL TOOLS .
- 61 9 040
IMPORTANT:
- Identify cause of damage (e.g. sharp-edged body parts, faulty electrical loads, jammed mechanisms, corrosion caused by ingress of water, etc.).
- Read out fault memory
- Eliminate cause of damage.
- Disconnect battery negative terminal
- Make sure that no safety-related system according to connection scheme (e.g. anti-lock braking system, active rear-axle kinematics, airbags, etc.) are influenced.
Otherwise replace faulty wiring harness or use repair cable
- Carry out function test and read out fault memories again
- Eliminate new faults if applicable and clear fault memories
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.