Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
61 13 040 Replacing distribution box (passenger compartment)
Necessary preliminary tasks:
- Remove luggage compartment trim on side panel on right . See 51 47 220 REMOVING AND INSTALLING/REPLACING TRUNK TRIM PANEL ON RIGHT SIDE PANEL .
- Disconnect negative battery cable .
- Remove trim for instrument panel, bottom left . See 51 45 181 REMOVING AND INSTALLING/REPLACING BOTTOM RIGHT TRIM FOR INSTRUMENT PANEL .
- Remove right glovebox with housing . See 51 16 366 REMOVING AND INSTALLING RIGHT GLOVEBOX WITH HOUSING .
Release screws (1) and remove distribution box (2).
Disconnect all plug connections (1).
Unlock relay base (3) and disconnect.
Open cover (2) on positive battery cable and release nut underneath.
Tightening torque, see 61 21 2AZ in 61 21 BATTERY WITH TERMINAL
Disconnect positive battery cable from distribution box.
Installation:
Make sure positive battery cable is correctly seated on fuse box.
Replacement:
Remove fuses.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.