Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 2212 (SEATS - REPAIR)REAR SEAT THROUGH-LOADING52 26... REMOVING AND INSTALLING/REPLACING SKI BAG (THROUGH-LOADING) AND FRAME

2013 Mini Cooper Countryman, Standard Trans

52 26... Removing and installing/replacing ski bag (through-loading) and frame

2013 Mini Cooper Countryman, Standard TransSECTION 52 26... Removing and installing/replacing ski bag (through-loading) and frame

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Removing ski bag:

Fold back center armrest
Unlock handle strip towards top

Fig 1: Removing Ski Bag
Courtesy of BMW OF NORTH AMERICA, INC.
Remove ski bag (1) towards front

Removing frame for ski bag:

Remove ski bag
Remove screw cover, release screws (1)
Tightening torque: see 6AZ in 52 26 REAR SEATS (THROUGH-LOADING SYSTEM) .
Fold backrest forwards slightly
Feed in special tool 00 9 317 in area (2) between trim and frame and unclip frame towards rear
Remove frame towards rear bottom

Fig 2: Identifying Ski Bag Screws
Courtesy of BMW OF NORTH AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.