Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
32 31 020 Removing and installing / replacing lower section of steering column trim
Necessary preliminary tasks:
- Remove FRONT SECTION OF TRIM
- Move steering column in "top" and "extended" position.
Release screw.
Unclip lower trim section (1).
If necessary, unclip wiring harness from lower trim section (1).
Installation:
Replace expansion rivet.
Installation:
Locks (2) must engage in hooks (1) on both sides.
Unclip steering column cover (1) from lower section of trim (2).
Remove lower section of trim (2).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.