Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
13 0 190 Assembly kit
Minimum set: Mechanical tools
Note: For removing and installing Teflon rings on injector.
Engine: N14, N43, N53, N54, N73H
SI number: 1 20 06 (299)
Order number: 13 0 190
Assembly kit
Consisting of:
1 = 13 0 191 Pliers
2 = 13 0 192 Installation sleeve 1
3 = 13 0 193 Installation sleeve 2
4 = 13 0 194 Installation sleeve 3
5 = 13 0 195 Installation taper
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.