Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 187 (AIR BAG RESTRAINT SYSTEMS)COMPONENT LOCATIONS
2013 Mini Cooper Countryman, Standard Trans
Component Locations
2013 Mini Cooper Countryman, Standard TransSECTION Component Locations
WARNING: This page is about a different car, the 2004 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
RESTRAINT SYSTEM COMPONENT LOCATIONS
| Component | Location |
|---|---|
| Air bag control unit | Under rear of center console |
| B-pillar sensors | Behind left & right B-pillar trim panels |
| Contact ring | On top of steering column, below steering wheel |
| Door sensors | Behind door trim panels |
| Driver-side air bag module | Front face of steering wheel |
| Knee air bag modules | Part of left & right knee bolsters |
| Passenger-side air bag module | Right side of instrument panel, above glove box |
| Passenger-side air bag deactivation switch | Right end of instrument panel |
| Safety battery terminal | Part of positive battery terminal, located in luggage compartment |
| Seat belt pretensioners | Part of left & right seat belt buckles |
| Side air bag module | Behind door trim panels |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.