Section 1841 (Electrical Component Locator): Switches

2013 Mini Cooper Countryman, Standard TransSECTION Switches
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW M5, 2008 BMW 550i, 2008 BMW 535xi, 2008 BMW 535i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
SWITCHES LOCATION

Component Location
Back-Up Light Switch (S8511) Rear of transmission. See Figure.
Brake Fluid Level Switch (B18a) Left rear engine compartment. See Figure.
Brake Light Switch (S29) Left side of dash. See Figure.
Clutch Module Switch (S805a) Under left side of dash. See Figure.
Coolant Level Switch (S63b) Right side of engine compartment. See Figure.
Hood Contact (S19) Right rear engine compartment. See Figure.
Oil Level Switch (S65) Right side of engine compartment. See Figure.
Oil Pressure Switch (B6231) (3.0L) Top front of engine. See Figure.
Oil Pressure Switch (B6231) (4.8L) Front of engine. See Figure.
Park Brake Switch (S31) Rear center console. See Figure.
Park/Neutral Position Switch (Y19) (W/O SMG) Center console. See Figure.
Park/Neutral Position Switch (Y19) (W/ SMG) Part of shifter lever. See Figure.
Radiator Blind Solenoid Switch (Y13864) Center of front bumper. See Figure.
Selector Lever Position Switch (S227) Part of shifter lever. See Figure.
Steptronic Switch (S224) Part of shifter lever. See Figure.
Washer Fluid Level Switch (S136) (Sedan) Front of left front wheel. See Figure.
Washer Fluid Level Switch (S136) (Wagon) Front of left front wheel. See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.