Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Selector Mechanism
Selection of the required driving mode, through the selector lever inside the vehicle, activates a selector shaft within the transmission. A push/pull type cable connects the lever in the car and the shaft on the gearbox. A cam fitted to the selector shaft is also connected to the manual valve of the control system, and selects one of its five desired positions (PRNDS/M). Moving the selector lever across the gate trips a proximity sensor. A spring and cone operated pawl mechanically locks the secondary pulley when the selector lever is moved to the Park position. If selection of park is made at speed the pawl will rattle without engaging Park. It will not engage until the vehicle speed drops below approximately 3 mph. See Fig 1 .
Movement of the selector lever (or steering wheel buttons) in a forward direction, plus (+), changes the transmission up the gear ratios and movement in a rearward direction, minus (-), changes the transmission down the gear ratios. See Fig 2 and Fig 3 .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.