Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Transmission Fluid
- Initial production transmissions are factory filled with DEXRON III.
- Later production transmissions are factory filled with Texaco ETL-7045 lifetime oil.
When the transition occurs, the fluid type will be noted by a label change on the transmission pan indicating the actual fluid type in the transmission. Transmissions filled with Texaco 7045 Dexron III can be "topped off" with the Texaco ETL- 7045 oil if required after performing the oil level checking procedure with the DIS/MoDiC. Fill capacity is approximately 7 liters (not including torque converter). Approximately 8 liters (including torque converter). See Fig 1 .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.