Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 170 (TRANSMISSION - OVERVIEW)SERVICE INFORMATIONSERVICE AND REPLACEMENT PARTSLIMITED SERVICE REPAIRS
2013 Mini Cooper Countryman, Standard Trans
Limited Service Repairs
2013 Mini Cooper Countryman, Standard TransSECTION Limited Service Repairs
WARNING: This page does not describe the selected car, but rather 43 other vehicles, including the 2006 BMW M3, 2006 BMW 330Ci, 2006 BMW 325Ci, 2005 BMW M3, and 2005 BMW 330xi. However, it is still accessible from the selected car via links, so may be relevant.
Minor electrical and mechanical repairs can be performed on the A5S 360R. See Fig 1 . The following are included in the repair scope of the A5S 360R:
- Service Parts: Oil filter unit, pan gasket, oil filler and drain plugs with seals.
- Oil Leaks: Radial seals and gaskets.
- Mechanical Faults: Torque converter core replacement, parking pawl mechanism.
- Hydraulic Control Faults - valve body replacement.
- Electrical Faults - shift solenoids, torque converter pressure regulator and main line oil pressure regulator, wiring harness (fluid temperature sensor), range selector switch, turbine and output speed sensors.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.