Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1563 (TRANSFER CASE - REPAIR)
2013 Mini Cooper Countryman, Standard Trans
Section 1563 (Transfer Case - Repair)
2013 Mini Cooper Countryman, Standard TransSECTION Section 1563 (Transfer Case - Repair)
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- 00 Transfer Case, General
- 10 Transfer Case
- 27 10 010 Removing and Installing Transfer Box ATC 700 (Automatic Transmission)
- 27 10 020 Installing distributor exchange transmission (ATC 450)
- 27 10 020 Installing Replacement Transfer Box (ATC 700)
- 27 10 020 Installing replacement transfer box (ATC 350)
- 27 10 050 Replacing output flange for front axle output (ATC 450)
- 27 10 070 Replacing Output Flange on Transfer Box at Rear (ATC 700)
- 27 10 070 Replacing output flange on transfer box at rear (ATC450)
- 27 10 700 Removing and Installing / Replacing Control Unit for Transfer Box (ATC 700)
- 27 10 710 Replacing Classification Resistor for Servomotor (ATC 700)
- 27 10 710 Replacing classification resistor for control motor S63 (ATC 700)
- 27 10 720 Replacing Servomotor (ATC 700)
- 27 10 730 Replacing VTG control unit (longitudinal torque module) (ATC 450)
- 21 Transmission Shafts
- 27 21 010 Replacing Radial Shaft Seal for Drive Flange (ATC 700)
- 27 21 020 Replacing Radial Shaft Seal for Output Flange (ATC 700)
- 27 21 020 Replacing radial shaft seal for output flange (ATC 450)
- 27 21 030 Replacing Radial Shaft Seal for Front Axle Output (ATC 700)
- 27 21 030 Replacing radial shaft seal for front axle output (ATC 450)
- 27 21 040 Replacing radial shaft seal for actuator shaft (ATC 450)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.