Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
86 21 ... Removing Side Lid Hinge
refer to 86 21 ... REMOVING LID .
Remove gas spring, remove gas spring on hinge side only,
refer to 86 21 ... REMOVING GAS SPRING .
Unscrew bolt (1). Remove hinge (2). If fitted, remove spacer plate(s) (3).
Installation:
Pass screws (1) again through spacer tubes. Reinstall existing spacer plate(s) in its/their original position(s). Use new self-locking nuts.
Tightening Torque, refer to 86 21 HOOD .
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.