Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
86 10 ... Replacing 12 Volt Socket
From underside of platform, cut through cable tie (1) and remove. Disconnect plug with grommet (2) from socket (3) towards bottom.
Installation:
Position all seals correctly. Also secure plug with grommet (2) using new cable tie to other socket.
On upper side of platform, release Phillips screws (1) on mounting bracket (2).
Remove sealing compound along white marking (1).
Installation:
Make sure cable is correctly laid.
Use Sikaflex 221 as sealing compound.
Grip under mounting bracket (1) with a screwdriver and lever out bracket (1) towards top. Remove bracket (1).
Release nut (1). Remove socket (2) from mounting bracket (3).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.