Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1493 (GENERAL ELECTRICAL SYSTEM - TIGHTENING TORQUES)31 SWITCH61 31 SWITCH
2013 Mini Cooper Countryman, Standard Trans
61 31 Switch
2013 Mini Cooper Countryman, Standard TransSECTION 61 31 Switch
WARNING: This page is about a different car, the 2010 BMW 650i, 2009 BMW 650i, 2008 BMW 650i, 2007 BMW 650i, and 2006 BMW 650i. However, it is still accessible from the selected car via links, so may be relevant.
SWITCH - TIGHTENING TORQUES SPECIFICATION
| Type | Thread | Tightening specification | Measure | ||
|---|---|---|---|---|---|
| 1AZ | Ignition starter switch | E60 / E61 / E63 / E64 | 0.4 Nm | ||
| 2AZ | Reversing light switch | E36 / E38 / E39 / E46 / E53 / E60 / E61 / E63 / E64 / E81 / E82 / E83 / E85 / E86 / E87 / E90 / E91 / E92 / E93 | M12 | 16 Nm | |
| 3AZ | Trim, gear selector switch | E70 | M4 | 2 Nm | |
| 4AZ | Gear selector switch | E70 | M5 | 5 Nm | |
| 5AZ | Controller | E70 | M4 | 1.5 Nm | |
| 6AZ | Gear selector switch | E60 / E61 | M6 x 12 | 7.5 Nm | |
| 7AZ | Emergency release to gear selector switch | E60 / E61 | 4 x 12 | 1.6 Nm | |
| 8AZ | Switch cluster to steering column | E70 / E71 / E72 / E81 / E82 / E87 / E88 / E89 / E90 / E91 / E92 / E93 | M4 | 5-7 Nm | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.