61 31 195 Removing And Installing (Replacing) Front Controller

2013 Mini Cooper Countryman, Standard TransSECTION 61 31 195 Removing And Installing (Replacing) Front Controller
WARNING: This page is about a different car, the 2006 BMW 760i, 2005 BMW 760i, and 2004 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Operation is described in:
Remove and install decorative strip on center armrest  . See 51 16 197 REMOVING AND INSTALLING/REPLACING DECORATIVE TRIM ON CENTER ARMREST .

Replacement: 

Carry out coding/programming.

Observe following IDC specifications:

  • Programming
  • Coding
  • Car & Key Memory
  • CD "CIP"
    Fig 1: Identifying IDC
    G04740355Courtesy of BMW OF NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.