33 90... Troubleshooting Shock Absorber

2013 Mini Cooper Countryman, Standard TransSECTION 33 90... Troubleshooting Shock Absorber
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Read and comply with Information on replacing shock absorbers  . See 33 00... INFORMATION ON REPLACING SHOCK ABSORBERS 

TROUBLESHOOTING TABLE

Fault Cause Remedy
Wheel knocking (bottoming) Auxiliary spring faulty Visually inspect auxiliary spring for cracking, replace auxiliary spring
Shock absorber leaking (oil/gas) Replace shock absorber  . See SPRING STRUT SHOCK ABSORBER .
Rattling noise Shock absorber mounting loose Tighten shock absorber  . See SPRING STRUT SHOCK ABSORBER .
Support bearing loose Secure support bearing  . See 33 52 SHOCK ABSORBERS .
Support bearing defective (cracked) Visually inspect for cracking, replace support bearing.
Protective tube defective/failed Visually inspect protective tube for cracking, replace protective tube
Rubber mount/joint eye for lower shock absorber mounting defective Replace rubber mount/joint eye
Shock absorber leaking (oil/gas) Replace shock absorber  . See 33 52 SHOCK ABSORBERS .
Worn down areas (flattened areas) on tire profile Shock absorber leaking (gas/oil) Replace shock absorber  . See 33 52 SHOCK ABSORBERS .
Long after-swinging of body after driving over rough road Shock absorber leaking (insufficient shock absorber effect) Replace shock absorber  . See 33 52 SHOCK ABSORBERS .
Building-up of body in case of successive uneven surfaces Shock absorber leaking (insufficient shock absorber effect) Replace shock absorber  . See 33 52 SHOCK ABSORBERS .
Wheels jumping even on normal road surfaces Shock absorber leaking (insufficient shock absorber effect) Replace shock absorber  . See 33 52 SHOCK ABSORBERS .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.