13 62 010 Removing and Installing/Replacing Right Differential Pressure Sensor (N73)

2013 Mini Cooper Countryman, Standard TransSECTION 13 62 010 Removing and Installing/Replacing Right Differential Pressure Sensor (N73)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, 2005 BMW 760i, and 2005 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks: 

  • Switch off ignition.

Unlock plug (1) and remove.

Release screws on differential pressure sensor.

Remove differential pressure sensor (2).

Fig 1: Identifying Plug & Differential Pressure Sensor
G04774037Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Check function of DME.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.