Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1399 (STEERING AND WHEEL ALIGNMENT - SERVICE INFORMATION)32 STEERING AND WHEEL ALIGNMENT14. MODIFICATIONS WITHIN PROGRAM
2013 Mini Cooper Countryman, Standard Trans
14. Modifications Within Program
2013 Mini Cooper Countryman, Standard TransSECTION 14. Modifications Within Program
WARNING: This page is about a different car, the 2007 BMW 530xi, 2007 BMW 525xi, 2006 BMW 530xi, and 2006 BMW 525xi. However, it is still accessible from the selected car via links, so may be relevant.
Further modifications were carried out within the program which only slightly change the program sequence but which optimize the alignment in respect of comfort and speed. This is described below:
- Optimization of the rim run-out compensation in respect of speed.
- Optimization of the steering routines: Highlighted values within the gate can still be corrected. The message "Rotating plates not connected" no longer causes the steering routine to be cancelled. Further measurements can be carried out after the rotating plates have been connected.
- Standardization of screen colors with the colors on the tablet.
- Addition of texts in several foreign languages.
- Elimination of program-related and cosmetic faults.
- Electronic water level.
- Omission of kingpin inclination measurement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.