Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 138 (BRAKES - REPAIR)TESTINGBRAKE SYSTEMHIGH-PRESSURE TEST
2013 Mini Cooper Countryman, Standard Trans
High-Pressure Test
2013 Mini Cooper Countryman, Standard TransSECTION High-Pressure Test
WARNING: This page is about a different car, the 2004 BMW Z4 and 2003 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform test on both brake circuits, front and rear.
- Unscrew bleeder screw, connect pressure tester and bleed. See Figure .
- Load brake pedal with a force of approximately 112 lbs. (500 N), and block pedal with pedal support.
- After 2 minutes, pressure must not drop by more than 8 percent.
- Perform low-pressure test. See LOW PRESSURE TEST .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.