Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
86 10... Removing Left Or Right Shock Absorber
Inspect the shock absorber while installed to ascertain whether it needs to be replaced.
Replace shock absorber if it is leaking. Replace shock absorber if it can be easily pushed in or pulled out when removed.
Release screw (1) and remove. Tilt shock absorber in direction of arrow. Release screw (2) and remove shock absorber.
Installation:
Hold shock absorber vertically: protective cap points upwards. Completely press in shock absorber once and pull out up to required installation length. Do not tilt shock absorber further than is needed for installation.
Tightening Torque: refer to 86 10 21AZ . See PLATFORM for specs.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.