Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
86 21... Installing Hood Seal
Removing old seal:
In a straight area of hood, grip old seal piping with a pair of pliers and pull off horizontally. Grip detached seal with both hands and uniformly pull away from hood ridge.
Push seal piping (1) by hand onto hood ridge (2). Using a rubber hammer, gently tap seal piping (1) as far as it will go onto hood ridge (2). Make sure piping is evenly positioned especially in radii of hood ridge.
Installation:
Position end face of seal at front end of hood in a straight area. Lay seal from front to rear.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.