Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Manual Steering-Column Adjustment
The driver is able to adjust the steering column with a switch. When the switch is operated, the signal is transmitted cyclically from terminal 30 (cycle time: 100 milliseconds). The steering-column adjustment is actuated for as long as the signal is being received.
Once the switch is no longer actuated, the message "Stop" is transmitted 3 times.
The steering-column adjustment is stopped when this signal is received, or if the cyclic message is not received twice.
To enable a failure of the steering column switch cluster to be detected, a further a cyclic message is transmitted when the data bus is active (cycle time: 1 second).
When changing the direction of adjustment, the centre console switch cluster first actuates the switching motor.
The actuation of this motor is time-dependent. The adjustment motor is not actuated until the direction of adjustment is correctly set. The total adjustment movement is no more than 36 millimetres for tilt adjustment and 40 millimetres for reach adjustment.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.