33 90 ... Troubleshooting Shock Absorber

2013 Mini Cooper Countryman, Standard TransSECTION 33 90 ... Troubleshooting Shock Absorber
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Read and comply with INFORMATION ON REPLACING SHOCK ABSORBERS .

SHOCK ABSORBER TROUBLESHOOTING CHART

Fault Cause Remedy
Wheel knocking (bottoming) Auxiliary spring faulty Visually inspect auxiliary spring for cracking, replace AUXILIARY SPRING 
Shock absorber leaking (oil/gas) Replace SHOCK ABSORBER 
Rattling noise Shock absorber mounting loose Tighten SHOCK ABSORBER 
Support bearing loose Secure SUPPORT BEARING
Support bearing defective (cracked) Visually inspect for cracking, replace SUPPORT BEARING 
Protective tube defective/failed Visually inspect protective tube for cracking, replace protective tube
Rubber mount/joint eye for lower shock absorber mounting defective Replace rubber mount/joint eye
Shock absorber leaking (oil/gas) Replace SHOCK ABSORBER 
Worn down areas (flattened areas) on tyre profile Shock absorber leaking (gas/oil) Replace SHOCK ABSORBER 
Long after-swinging of body after driving over rough road Shock absorber leaking (insufficient shock absorber effect) Replace SHOCK ABSORBER 
Building-up of body in case of successive uneven surfaces Shock absorber leaking (insufficient shock absorber effect) Replace SHOCK ABSORBER 
Wheels jumping even on normal road surfaces Shock absorber leaking (insufficient shock absorber effect) Replace SHOCK ABSORBER 
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.