SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1274 (STEERING AND WHEEL ALIGNMENT - REPAIR)ELECTRONIC CHASSIS ALIGNMENT31 00... FRONT AXLE + STEERING: WHEEL/CHASSIS ALIGNMENT CHECK MUST BE CARRIED OUT AFTER THE FOLLOWING WORK
2013 Mini Cooper Countryman, Standard Trans

31 00... Front axle + steering: wheel/chassis alignment check must be carried out after the following work

2013 Mini Cooper Countryman, Standard TransSECTION 31 00... Front axle + steering: wheel/chassis alignment check must be carried out after the following work
WARNING: This page is about a different car, the 2010 BMW M5, 2009 BMW M5, 2008 BMW M5, 2007 BMW M5, and 2006 BMW M5. However, it is still accessible from the selected car via links, so may be relevant.

A wheel/chassis alignment check must be carried out after the following work:

  • Release of following screw/bolt connections: 
    • Steering gear to front axle carrier
    • Control arm to front axle carrier
    • Support bearing to body (if centering pin is missing)
    • Tie rod end to tie rod
  • Replacement of following parts: 
    1. Front axle carrier
    2. Steering gear
    3. Gaiter (if the tie rod end has to be screwed off)
    4. Control arm
    5. Support bearing (if centering pin is missing)
    6. Swivel bearing
    7. Tie rod end
    8. Tie rod
    • Fig 1: Identifying Front Axle And Steering Components
    G04742322Courtesy of BMW OF NORTH AMERICA, INC.

See ALIGNMENT CHECK WITH LOAD UP TO DESIGN POSITION  or ALIGNMENT CHECK WITH RIDE-HEIGHT MEASUREMENT WITHOUT LOAD .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.