Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2013COOPER COUNTRYMAN, STANDARD TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1262 (STEERING AND WHEEL ALIGNMENT - TECHNICAL DATA)00 ELECTRONIC CHASSIS ALIGNMENT32 00 WHEEL ALIGNMENT E60 CHL (LONG WHEELBASE)
2013 Mini Cooper Countryman, Standard Trans
32 00 Wheel Alignment E60 CHL (Long Wheelbase)
2013 Mini Cooper Countryman, Standard TransSECTION 32 00 Wheel Alignment E60 CHL (Long Wheelbase)
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
TECHNICAL DATA - WHEEL ALIGNMENT E60 CHL (LONG WHEELBASE) (32 00)
| Observe Test Conditions! | ||
| Front axle: | ||
| Total toe | 0° 12' ± 10' | |
| Camber (difference between left/right max. 30') | - 05' ± 20' | |
| Toe angle difference | (difference between left/right max. 30') | |
| - with 20° lock on inside wheel | - 1° 42' ± 30' | |
| Caster angle | (difference between left/right max. 30') | |
| Front wheel displacement | 0° ± 15' | |
| Maximum wheel lock | ||
| - Inside wheel | 43° 22' | |
| - Outside wheel | 34° 06' | |
| Rear axle: | ||
| Total toe | 0° 18' ± 10' | |
| Camber (difference between left/right max. 15') | 2° 00' ± 20' | |
| Geometrical axis deviation | 0° ± 12' |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.