Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2008COOPER S CLUBMAN (R55) L4-1.6L TURBO (N14)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSRELAYS AND MODULES - TRANSMISSION AND DRIVETRAINRELAYS AND MODULES - A/TCONTROL MODULESERVICE AND REPAIR
2008 Mini Cooper S Clubman (R55) L4-1.6L Turbo (N14)
Control Module: Service and Repair
2008 Mini Cooper S Clubman (R55) L4-1.6L Turbo (N14)SECTION Service and Repair
24 61 500 Removing and installing or replacing transmission control unit
Clamp off battery.
Release screw (1).
Detach retaining bracket (2) from control unit.
Tightening torque 24 61 1AZ.
Disconnect connector (3) and remove control unit from bracket.
IMPORTANT: The adaptation values must be reset after the control unit has been replaced.
NOTE: Graphic similar.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.