Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2008COOPER CLUBMAN (R55) L4-1.6L (N12)REPAIR AND DIAGNOSISSERVICE AND REPAIR61 13 ... CRIMPING MICRO POWER QUADLOCK CONTACTS (MPQ)
2008 Mini Cooper Clubman (R55) L4-1.6L (N12)
61 13 ... Crimping Micro Power Quadlock Contacts (MPQ)
2008 Mini Cooper Clubman (R55) L4-1.6L (N12)SECTION 61 13 ... Crimping Micro Power Quadlock Contacts (MPQ)
61 13 ... Crimping Micro Power Quadlock Contacts (MPQ)
Special tools required:
To crimp MPQ contacts, use hand pliers 61 4 321 (1) in conjunction with crimping head 61 4 325 (2) from crimping set 61 4 320 61 4 320 Crimping Tool
NOTE: Hand pliers (1) open automatically as far as they will go when handles are pressed together.
Open hand pliers (1).
NOTE: Place contact (2) with utmost care in designated nest (observe line cross-section) in crimping head (3). Make sure it is exactly positioned.
Place MPQ contact (2) in crimping head (3).
Close hand pliers (1) one notch.
NOTE: Follow procedure for cutting and stripping insulation from cables 61 13 ... Cutting to Length and Stripping Insulation From Cables
Insert stripped cable (2).
Close hand pliers (1) fully.
Open hand pliers (1) and remove cable (2).
IMPORTANT: Check contact for correct crimping 61 13 ... Crimping Stop Parts
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.