Air Bag Control Module: Service and Repair

2008 Mini Cooper Clubman (R55) L4-1.6L (N12)SECTION Service and Repair



65 77 016 - Removing and installing airbag control unit





Warning!
Comply with airbag safety regulations [1][2][3]Safety Precautions and General Information.
Incorrect handling can activate airbag and cause injury.





Necessary preliminary tasks:
- Disconnect battery negative lead [1][2]12 00 ... Instructions For Disconnecting and Connecting Battery
- Remove center console 51 16 200 Removing and Installing Storage Compartment





Release nut (1) and disconnect ground cable (2).
Unscrew nuts (3).
Tightening torque 65 77 1AZ 65 77 Airbag Control Unit and Airbag Sensors.
Raise center console bracket (4) in direction of arrow and carefully feed out airbag control unit.





Disconnect plug connections (1) and remove airbag control unit (2).

Installation Note:
Make sure cables are correctly laid.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.