Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2008COOPER CLUBMAN (R55) L4-1.6L (N12)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTUNE-UP AND ENGINE PERFORMANCE CHECKSCOMPRESSION CHECKTESTING AND INSPECTION
2008 Mini Cooper Clubman (R55) L4-1.6L (N12)
Compression Check: Testing and Inspection
2008 Mini Cooper Clubman (R55) L4-1.6L (N12)SECTION Testing and Inspection
11 00 039 - Checking compression of all cylinders (N12, N14)
- Read out fault memory of DME control unit
- Check stored faults
- Rectify faults
- Clear fault memory
Important!
High tension - mortal danger!
Interrupt power supply to ignition coils.
Read and comply with notes on compression pressure check.
Necessary preliminary tasks:
- Remove spark plugs Service and Repair.
Unscrew tip (1) from special tool 11 0 222.
Important!
Then check the Schrader valve that is now visible for secure seating.
Prepare special tool 11 0 222 in conjunction with 11 8 732 and 11 8 731.
Screw special tool 11 0 222 onto special tool 11 8 731 to 10 Nm.
Important!
Do not forget to oil spark plug thread of special tool 11 8 731.
Screw special tool 11 0 222 by hand into spark plug thread and connect special tool 11 0 224.
Use adapter lead (1) if the compression pressure is being checked with the BMW diagnosis system.
Depress accelerator pedal and actuate starter until compression pressure stops rising.
- Nominal values, compression pressure
Assemble engine
Now clear the fault memory.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.