Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2008COOPER CLUBMAN (R55) L4-1.6L (N12)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTECHNICAL SERVICE BULLETINSALL TECHNICAL SERVICE BULLETINSCOMPUTERS/CONTROLS - ISTA TEST PLAN PRIORITY ERROR
2008 Mini Cooper Clubman (R55) L4-1.6L (N12)
Computers/Controls - ISTA Test Plan Priority Error
2008 Mini Cooper Clubman (R55) L4-1.6L (N12)SECTION Computers/Controls - ISTA Test Plan Priority Error
SI M 07 02 10
Workshop Environment Systems
January 2010
Technical Service
SUBJECT
ISTA Test Plan Priority Error
MODEL
All
SITUATION
When diagnosing a vehicle using ISTA (Integrated Service Technical Application), fault code test plans are intended to be listed by "Priority". However, the priority given to test plans by ISTA may not be reliable. This may lead to unnecessary diagnosis being performed.
CAUSE
When ISTA was introduced, the entire diagnostics from DIS were migrated over to ISTA. Until all of the diagnostic data has been revised within ISTA, this type of error may occur.
PROCEDURE
Before starting diagnosis, the entire test schedule should be considered. Always use fault symptom diagnosis when available, and use the customer complaint as the basis for determining which test plan to start first.
Note:
With each ISTA release, the priority given in the test schedule will become more reliable.
WARRANTY INFORMATION
For information only
Workshop Environment Systems
January 2010
Technical Service
SUBJECT
ISTA Test Plan Priority Error
MODEL
All
SITUATION
When diagnosing a vehicle using ISTA (Integrated Service Technical Application), fault code test plans are intended to be listed by "Priority". However, the priority given to test plans by ISTA may not be reliable. This may lead to unnecessary diagnosis being performed.
CAUSE
When ISTA was introduced, the entire diagnostics from DIS were migrated over to ISTA. Until all of the diagnostic data has been revised within ISTA, this type of error may occur.
PROCEDURE
Before starting diagnosis, the entire test schedule should be considered. Always use fault symptom diagnosis when available, and use the customer complaint as the basis for determining which test plan to start first.
Note:
With each ISTA release, the priority given in the test schedule will become more reliable.
WARRANTY INFORMATION
For information only
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.