Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMINI2008COOPER CLUBMAN (R55) L4-1.6L (N12)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSOIL PRESSURE SENSORSERVICE AND REPAIR
2008 Mini Cooper Clubman (R55) L4-1.6L (N12)
Oil Pressure Sensor: Service and Repair
2008 Mini Cooper Clubman (R55) L4-1.6L (N12)SECTION Service and Repair
12 61 280 - Removing and installing/replacing oil pressure sensor (N12)
Special tools required:
- 11 7 020 11 7 020 Socket Wrench Insert
Warning!
Scalding hazard!
Only perform this task on an engine that has cooled down.
Necessary preliminary tasks:
- Switch off ignition
Installation location:
On cylinder head, left.
Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.
Release screw.
Pull intake muffler (1) towards top and detach clean air pipe (2).
Detach intake muffler (1) from air filter housing and remove.
Remove clean air pipe (2).
Unlock and detach plugs (1 and 2).
Unlock and disconnect line (3).
Carefully pull cable duct (4) upwards slightly.
Release oil pressure sensor (1) with special tool 11 7 020.
Installation Note:
- Replace sealing ring.
- Tightening torque 12 61 1AZ. Mechanical Specifications
- Check engine oil level, top up engine oil if necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.