Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MOUNTAINEER AWD V6-4.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESDIAGNOSTIC MONITORING TEST RESULTS MODE 6
2010 Mercury Mountaineer AWD V6-4.0L
Diagnostic Monitoring Test Results Mode 6
2010 Mercury Mountaineer AWD V6-4.0LSECTION Diagnostic Monitoring Test Results Mode 6
DIAGNOSTIC MONITORING TEST RESULTS MODE 6
Mode 6 allows access to the results of on board diagnostic (OBD) monitor diagnostic test results. The test values are stored at the time of the particular monitor completion. Refer to mode 6 on the scan tool for test information.
Mode 6 allows access to the results of on board diagnostic (OBD) monitor diagnostic test results. The test values are stored at the time of the particular monitor completion. Refer to mode 6 on the scan tool for test information.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.