Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MOUNTAINEER AWD V6-4.0LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTCELLULAR PHONECOMMUNICATIONS CONTROL MODULESERVICE AND REPAIRREMOVAL AND REPLACEMENTAUDIO CONTROL MODULE (ACM)
2010 Mercury Mountaineer AWD V6-4.0L
Audio Control Module (ACM)
2010 Mercury Mountaineer AWD V6-4.0LSECTION Audio Control Module (ACM)
Audio Control Module (ACM)
Removal and Installation
NOTE: It is not necessary to remove the Audio Control Module (ACM) to retrieve the part number. For additional information, refer to Audio Control Module (ACM) Self-Diagnostic Mode Audio Control Module (ACM) Self-Diagnostic Mode.
1. NOTE: Module configuration is required when a new ACM is being installed.
Upload the ACM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in Information Bus. Programmable Module Installation (PMI)
2. Remove the instrument panel center finish panel. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
3. Remove the 4 screws and the ACM.
- Disconnect the ACM electrical connectors.
4. To install, reverse the removal procedure.
- Download the configuration information to the ACM. For additional information, refer to PMI in Information Bus. Programmable Module Installation (PMI)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.