Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MOUNTAINEER 4WD V6-4.0LREPAIR AND DIAGNOSISMAINTENANCEWHEELS AND TIRESTIRE MONITORING SYSTEMTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGTIRE PRESSURE MONITORING SYSTEM (TPMS) SENSOR ACTIVATION
2010 Mercury Mountaineer 4WD V6-4.0L
Tire Pressure Monitoring System (TPMS) Sensor Activation
2010 Mercury Mountaineer 4WD V6-4.0LSECTION Tire Pressure Monitoring System (TPMS) Sensor Activation
Tire Pressure Monitoring System (TPMS) Sensor Activation
NOTE: The tire pressure sensors will go into a "sleep mode" after 30 minutes of inactivity to conserve battery power. The sensors do not transmit information while in sleep mode. It will be necessary to wake them up so they will transmit the latest tire pressure information.
1. Turn the ignition switch to the ON position.
2. Position the Tire Pressure Monitor Activation Tool against the LF tire sidewall, 180 degrees from the tire valve stem.
3. NOTE: The Tire Pressure Monitor Activation Tool will provide feedback in the form of a flashing green light and a beep sound for each successful response from a tire pressure sensor.
Press the test button on the Tire Pressure Monitor Activation Tool to activate the sensor, activate the sensor at least 2 times.
4. Repeat Steps 2 and 3 for the remaining tires.
5. If the Tire Pressure Monitoring System (TPMS) indicator remains illuminated after adjusting and activating each sensor, refer to the Symptom Chart in Diagnosis and Testing. Symptom Related Diagnostic Procedures
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.