Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MOUNTAINEER 2WD V8-4.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSPRESSURE FEEDBACK EXHAUST SENSORDESCRIPTION AND OPERATION
2010 Mercury Mountaineer 2WD V8-4.6L
Pressure Feedback Exhaust Sensor: Description and Operation
2010 Mercury Mountaineer 2WD V8-4.6LSECTION Description and Operation
ENGINE CONTROL COMPONENTS
Differential Pressure Feedback Exhaust Gas Recirculation (EGR) Sensor
The differential pressure feedback EGR sensor is a ceramic, capacitive-type pressure transducer that monitors the differential pressure across a metering orifice located in the orifice tube assembly. The differential pressure feedback EGR sensor receives this signal through 2 hoses referred to as the downstream pressure hose (REF SIGNAL) and upstream pressure hose (HI SIGNAL). The HI and REF hose connections are marked on the differential pressure feedback EGR sensor housing for identification (note the HI signal uses a larger diameter hose). The differential pressure feedback EGR sensor outputs a voltage proportional to the pressure drop across the metering orifice and supplies it to the PCM as EGR flow rate feedback.
Differential Pressure Feedback EGR Sensor - Tube Mounted
The tube mounted differential pressure feedback EGR sensor is identical in operation as the larger plastic differential pressure feedback EGR sensors and uses a 1.0 volt offset. The HI and REF hose connections are marked on the side of the sensor.
Differential Pressure Feedback Exhaust Gas Recirculation (EGR) Sensor
The differential pressure feedback EGR sensor is a ceramic, capacitive-type pressure transducer that monitors the differential pressure across a metering orifice located in the orifice tube assembly. The differential pressure feedback EGR sensor receives this signal through 2 hoses referred to as the downstream pressure hose (REF SIGNAL) and upstream pressure hose (HI SIGNAL). The HI and REF hose connections are marked on the differential pressure feedback EGR sensor housing for identification (note the HI signal uses a larger diameter hose). The differential pressure feedback EGR sensor outputs a voltage proportional to the pressure drop across the metering orifice and supplies it to the PCM as EGR flow rate feedback.
Differential Pressure Feedback EGR Sensor:
Differential Pressure Feedback EGR Sensor - Tube Mounted
The tube mounted differential pressure feedback EGR sensor is identical in operation as the larger plastic differential pressure feedback EGR sensors and uses a 1.0 volt offset. The HI and REF hose connections are marked on the side of the sensor.
Differential Pressure Feedback EGR Sensor - Tube Mounted:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.