Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MOUNTAINEER 2WD V6-4.0LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW MOTORBACK WINDOW MOTORSERVICE AND REPAIR
2010 Mercury Mountaineer 2WD V6-4.0L
Back Window Motor: Service and Repair
2010 Mercury Mountaineer 2WD V6-4.0LSECTION Service and Repair
Window Regulator Motor - Rear
Removal and Installation
NOTE: The power rear window motor must be initialized when repairs are performed on any part of the power rear window system including when: the power rear window motor is removed from the window regulator drum housing, a new power rear motor is installed, a new power rear window regulator is installed, a new power rear window glass module is installed, and any operation in which grease or lubricants are applied to the power rear window system.
1. Remove the rear window glass regulator. For additional information, refer to Window Regulator - Rear Service and Repair.
2. Remove the 3 window regulator motor bolts.
- To install, tighten to 4 Nm (35 lb-in).
3. Remove the window regulator motor.
4. To install, reverse the removal procedure.
- Initialize the power rear window motor. For additional information, refer to Window Motor Initialization - Rear Window Motor Initialization - Rear.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.