Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY2010MOUNTAINEER 2WD V6-4.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTHROTTLE POSITION SENSORDESCRIPTION AND OPERATIONTHROTTLE POSITION (TP) SENSOR
2010 Mercury Mountaineer 2WD V6-4.0L
Throttle Position (TP) Sensor
2010 Mercury Mountaineer 2WD V6-4.0LSECTION Throttle Position (TP) Sensor
ENGINE CONTROL COMPONENTS
Throttle Position (TP) Sensor
The TP sensor is a rotary potentiometer sensor that provides a signal to the PCM that is linearly proportional to the throttle plate/shaft position. The sensor housing has a 3-blade electrical connector that may be gold plated. The gold plating increases the corrosion resistance on the terminals and increases the connector durability. The TP sensor is mounted on the throttle body. As the TP sensor is rotated by the throttle shaft, 4 operating conditions are determined by the PCM from the TP. These are:
- closed throttle (includes idle or deceleration)
- part throttle (includes cruise or moderate acceleration)
- wide open throttle (includes maximum acceleration or de-choke on crank)
- throttle angle rate
Throttle Position (TP) Sensor
The TP sensor is a rotary potentiometer sensor that provides a signal to the PCM that is linearly proportional to the throttle plate/shaft position. The sensor housing has a 3-blade electrical connector that may be gold plated. The gold plating increases the corrosion resistance on the terminals and increases the connector durability. The TP sensor is mounted on the throttle body. As the TP sensor is rotated by the throttle shaft, 4 operating conditions are determined by the PCM from the TP. These are:
- closed throttle (includes idle or deceleration)
- part throttle (includes cruise or moderate acceleration)
- wide open throttle (includes maximum acceleration or de-choke on crank)
- throttle angle rate
Typical TP Sensor:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.