Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1998SABLE V6-3.0L DOHC VIN SREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVEHICLE SPEED SENSORSERVICE AND REPAIRAX4S
1998 Mercury Sable V6-3.0L DOHC VIN S
AX4S
1998 Mercury Sable V6-3.0L DOHC VIN SSECTION AX4S
REMOVAL
1. Raise and suitably support vehicle.
2. Remove dual converter Y-pipe from exhaust system.
3. Remove heat shield from transaxle.
4. Disconnect Vehicle Speed Sensor (VSS) electrical connector.
5. Remove VSS retaining bolt and remove VSS from transaxle.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten VSS retaining bolt to 5-8 Nm (45-70 in lb).
1. Raise and suitably support vehicle.
2. Remove dual converter Y-pipe from exhaust system.
3. Remove heat shield from transaxle.
4. Disconnect Vehicle Speed Sensor (VSS) electrical connector.
5. Remove VSS retaining bolt and remove VSS from transaxle.
INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten VSS retaining bolt to 5-8 Nm (45-70 in lb).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.