Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMERCURY1998SABLE V6-3.0L DOHC VIN SREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SWITCHSERVICE AND REPAIR
1998 Mercury Sable V6-3.0L DOHC VIN S
Cruise Control Switch: Service and Repair
1998 Mercury Sable V6-3.0L DOHC VIN SSECTION Service and Repair
REMOVAL
1. Remove the driver side air bag module.
2. Disconnect connectors for LH and RH speed control actuator switches by depressing locking tang and pulling switch printed circuit and connector end out of electrical socket in steering wheel.
3. Remove two Torx (R) head screws retaining each speed control actuator switch to steering wheel.
4. Remove speed control actuator switches from steering wheel.
INSTALLATION
1. Position two new speed control actuator switches onto steering wheel and install four Torx (R) head screws.
2. Connect two speed control actuator switch harness connectors.
3. Install the driver side air bag module.
4. Check operation of speed control actuator switches.
1. Remove the driver side air bag module.
2. Disconnect connectors for LH and RH speed control actuator switches by depressing locking tang and pulling switch printed circuit and connector end out of electrical socket in steering wheel.
3. Remove two Torx (R) head screws retaining each speed control actuator switch to steering wheel.
4. Remove speed control actuator switches from steering wheel.
INSTALLATION
1. Position two new speed control actuator switches onto steering wheel and install four Torx (R) head screws.
2. Connect two speed control actuator switch harness connectors.
3. Install the driver side air bag module.
4. Check operation of speed control actuator switches.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.