Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2005MX-5 MIATA L4-1.8L DOHCREPAIR AND DIAGNOSISCRUISE CONTROLCRUISE CONTROL SERVOSERVICE AND REPAIR
2005 Mazda MX-5 Miata L4-1.8L DOHC
Cruise Control Servo: Service and Repair
2005 Mazda MX-5 Miata L4-1.8L DOHCSECTION Service and Repair
CRUISE ACTUATOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove in the order indicated below.
1. Connector
2. Actuator cable
3. Vacuum hose
4. Nut
5. Bolt
6. Cruise actuator
7. Bracket
3. Install in the reverse order of removal.
1. Disconnect the negative battery cable.
2. Remove in the order indicated below.
1. Connector
2. Actuator cable
3. Vacuum hose
4. Nut
5. Bolt
6. Cruise actuator
7. Bracket
3. Install in the reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.