Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2001626 ES V6-2.5L DOHCREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW SWITCHTESTING AND INSPECTIONPOWER WINDOW MAIN SWITCH
2001 Mazda 626 ES V6-2.5L DOHC
Power Window Main Switch
2001 Mazda 626 ES V6-2.5L DOHCSECTION Power Window Main Switch
1. Disconnect the negative battery cable.
2. Remove the driver's side front door trim.
3. Inspect for the continuity between the power window main switch terminals by using an ohmmeter.
4. When checking the driver's side window switch, connect the B+ to terminal H and connect the ground to the terminal F.
- If not as specified, replace the power window main switch.
2. Remove the driver's side front door trim.
3. Inspect for the continuity between the power window main switch terminals by using an ohmmeter.
4. When checking the driver's side window switch, connect the B+ to terminal H and connect the ground to the terminal F.
- If not as specified, replace the power window main switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.