Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA2001626 ES V6-2.5L DOHCREPAIR AND DIAGNOSISLIGHTING AND HORNSMAP LIGHTSERVICE AND REPAIR
2001 Mazda 626 ES V6-2.5L DOHC
Map Light: Service and Repair
2001 Mazda 626 ES V6-2.5L DOHCSECTION Service and Repair
MAP LIGHT REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove in the order as indicated below.
1. Lens
2. Map light bulb
3. Screw
4. Fastener
5. Map light
6. Connector
3. Install in the reverse order of removal.
Lens Removal Note
1. Insert a tape-wrapped, flathead screwdriver into the service hole.
2. Twist the flathead screwdriver indicated by the arrow to remove the lens.
1. Disconnect the negative battery cable.
2. Remove in the order as indicated below.
1. Lens
2. Map light bulb
3. Screw
4. Fastener
5. Map light
6. Connector
3. Install in the reverse order of removal.
Lens Removal Note
1. Insert a tape-wrapped, flathead screwdriver into the service hole.
2. Twist the flathead screwdriver indicated by the arrow to remove the lens.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.