Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1999MX-5 MIATA L4-1.8L DOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESOXYGEN SENSOR TEST RESULTS ACCESS PROCEDURE
1999 Mazda MX-5 Miata L4-1.8L DOHC
Oxygen Sensor Test Results Access Procedure
1999 Mazda MX-5 Miata L4-1.8L DOHCSECTION Oxygen Sensor Test Results Access Procedure
NOTE:
- This is a generic function.
1. Perform the NGS Tester Hook-up Procedure.
2. Move the cursor to GENERIC OBD II FUNCTIONS. Press the trigger key to enter this function.
3. Press CONT.
4. Move the cursor to OXYGEN SENSOR TEST RESULTS. Press the trigger key to enter this selection.
5. Select RICH TO LEAN THRESHOLD VOLTAGE or LEAN TO RICH THRESHOLD VOLTAGE.
Press the trigger key.
6. Read voltage.
7. Press the cancel key.
- This is a generic function.
1. Perform the NGS Tester Hook-up Procedure.
2. Move the cursor to GENERIC OBD II FUNCTIONS. Press the trigger key to enter this function.
3. Press CONT.
4. Move the cursor to OXYGEN SENSOR TEST RESULTS. Press the trigger key to enter this selection.
5. Select RICH TO LEAN THRESHOLD VOLTAGE or LEAN TO RICH THRESHOLD VOLTAGE.
Press the trigger key.
6. Read voltage.
7. Press the cancel key.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.