Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1997MILLENIA V6-2.5L DOHCREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - RESTRAINTS AND SAFETY SYSTEMSAIR BAG CONTROL MODULESERVICE AND REPAIR
1997 Mazda Millenia V6-2.5L DOHC
Air Bag Control Module: Service and Repair
1997 Mazda Millenia V6-2.5L DOHCSECTION Service and Repair
WARNING: Handling the SAS unit improperly can accidently deploy the air bag, which may seriously injure you. Read SERVICE WARNINGS, before handling the SAS unit.
1. Carry out the "Before Servicing" procedure.
2. Remove the heater unit.
3. Remove in the order shown.
4. Install in the reverse order of removal.
5. Follow the troubleshooting flowchart to verify that the air bag system is operating normally.
1. Nut
2. SAS unit
3. Wiring harness
4. Heater duct
5. Bolt
6. Nut
7. Bracket
Installation Note
SAS unit and bracket
1. If the bracket mounting area is damaged, repair the area to its original shape.
2. Position the SAS unit and bracket with the arrow on the SAS unit facing toward the front of vehicle. Install them and tighten the bolts and nuts to the specified torque.
1. Carry out the "Before Servicing" procedure.
2. Remove the heater unit.
3. Remove in the order shown.
4. Install in the reverse order of removal.
5. Follow the troubleshooting flowchart to verify that the air bag system is operating normally.
1. Nut
2. SAS unit
3. Wiring harness
4. Heater duct
5. Bolt
6. Nut
7. Bracket
Installation Note
SAS unit and bracket
1. If the bracket mounting area is damaged, repair the area to its original shape.
2. Position the SAS unit and bracket with the arrow on the SAS unit facing toward the front of vehicle. Install them and tighten the bolts and nuts to the specified torque.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.