Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMAZDA1991MX-6 L4-2184CC 2.2L SOHC TURBO F2REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMIGNITION TIMINGADJUSTMENTS
1991 Mazda MX-6 L4-2184cc 2.2L SOHC Turbo F2
Ignition Timing: Adjustments
1991 Mazda MX-6 L4-2184cc 2.2L SOHC Turbo F2SECTION Adjustments
1. Warm engine to operating temperature.
2. Turn all electrical loads "OFF."
3. Connect a tachometer and timing light.
Fig. 21 Test Connector:
4. Ground test connector (Green: 1-pin) with a jumper wire.
5. Check that idle speed is within specification. Adjust if needed.
750 ± 25 rpm (M/T in neutral, A/T in "P")
Fig. 24 Timing Mark:
6. Check that timing mark (Yellow) on crank pulley and mark on timing belt cover are aligned.
9° ± 1° BTDC
Fig. 25 Distributor Adjustment:
7. If mark is not aligned, loosen distributor lock bolt and turn distributor to adjust.
8. Tighten distributor lock bolt to 14 - 19 ft lb (19 - 25 Nm).
9. Remove test connector jumper wire.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.