Coolant Temperature Sensor/Switch (For Computer): Testing and Inspection

1990 Mazda 626 L4-2184cc 2.2L SOHC F2SECTION Testing and Inspection
WATER THERMOSWITCH

Testing Water Thermoswitch:






INSPECTION
1. Remove the Water thermoswitch.
2. Place the switch in water with a thermometer and heat up the water gradually.
3. Check the continuity of the terminals. If necessary, replace the switch.

CONNECTION GUIDE

WATER TEMPERATURE CONTINUITY

Below 65°C (149°F) YES

Above 72 ± 5°C (162 ± 41°F) NO
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.