Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2012CT 200H L4-1.8L (2ZR-FXE) HYBRIDREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMEPOWER MIRROR CONTROL MODULESERVICE AND REPAIRREMOVAL
2012 Lexus CT 200h L4-1.8L (2ZR-FXE) Hybrid
Removal
2012 Lexus CT 200h L4-1.8L (2ZR-FXE) HybridSECTION Removal
MIRROR (EXT): OUTER MIRROR CONTROL ECU: REMOVAL
1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG Disassembly
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH Disassembly
3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly
4. REMOVE DOOR ARMREST COVER (for Driver Side) Disassembly
5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for Driver Side) Disassembly
6. REMOVE DOOR ASSIST GRIP COVER (for Front Passenger Side) Disassembly
7. REMOVE DOOR ASSIST GRIP ASSEMBLY (for Front Passenger Side) Disassembly
8. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Disassembly
9. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for Front Passenger Side) Disassembly
10. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY
(a) Disconnect each connector.
(b) Remove the 2 screws and outer mirror control ECU assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.