Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSLEXUS2011HS 250H L4-2.4L (2AZ-FXE) HYBRIDREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - HVACCONTROL MODULE HVACSERVICE AND REPAIRBLOWER MOTOR CONTROLLERINSTALLATION
2011 Lexus HS 250h L4-2.4L (2AZ-FXE) Hybrid
Installation
2011 Lexus HS 250h L4-2.4L (2AZ-FXE) HybridSECTION Installation
HEATING / AIR CONDITIONING: BLOWER MOTOR CONTROLLER: INSTALLATION
1. INSTALL BLOWER MOTOR CONTROLLER
(a) Install the blower motor controller with the 2 screws.
(b) Connect the connector.
2. SET NO. 1 CONSOLE BOX MOUNTING BRACKET Installation
3. INSTALL NO. 2 CONSOLE BOX MOUNTING BRACKET Installation
4. INSTALL CONSOLE BOX Installation
5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation
6. INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY Installation
7. INSTALL INSTRUMENT SIDE PANEL RH Installation
8. INSTALL COWL SIDE TRIM BOARD RH
HINT
Use the same procedure for the RH side and LH side Installation.
9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation
10. INSTALL FRONT DOOR OPENING TRIM COVER RH
HINT
Use the same procedure for the RH side and LH side Installation.
11. INSTALL FRONT DOOR SCUFF PLATE RH
HINT
Use the same procedure for the RH side and LH side Installation.
12. INSTALL CONSOLE BOX RH Installation
13. INSTALL CONSOLE BOX LH Installation
14. INSTALL INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY (w/o Navigation System) Installation
15. INSTALL REMOTE TOUCH ASSEMBLY (w/ Navigation System) Installation
16. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
17. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
18. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY Installation
19. INSTALL CONSOLE BOX CARPET Installation
20. INSTALL REAR CONSOLE PANEL SUB-ASSEMBLY Installation
21. INSTALL FRONT CONSOLE UPPER PANEL GARNISH (w/o Seat Heater System) Installation
22. INSTALL FRONT CONSOLE UPPER PANEL GARNISH (w/ Seat Heater System) Installation
23. INSTALL FRONT CONSOLE BOX COVER Installation
24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Installation
25. INSTALL LUGGAGE COMPARTMENT FLOOR MAT Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.